You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
In most cases a bad mesh is the cause for non-converging NumCalc simulations. In some cases, however, this can also be caused by the clustering algorithm. If this is the case,, changing the settings
2. Main Parameters II
0 0 0 0.0000e+00 0 0 0
in the NC.inp file to
2. Main Parameters II
0 0 0 0.05 0 0 0
might solve the problem.
The text was updated successfully, but these errors were encountered:
In most cases a bad mesh is the cause for non-converging NumCalc simulations. In some cases, however, this can also be caused by the clustering algorithm. If this is the case,, changing the settings
in the NC.inp file to
might solve the problem.
The text was updated successfully, but these errors were encountered: