#WiFi_AVRISP

AVR ISP programmer over WiFi. Build upon ESP8266 and Arduino.

This project is build upon Arduino platform for ESP8266.

The system provides-

An AVR ISP programmer for programming over ISP for any generic AVR chip. Provides a we based configuration interface using library at ESP_ConfigStorage at git. Simple to use and implement. Instructions provided at instructables (working).

##ISP connection If the AVR target is powered by a different Vcc than what powers your ESP8266 chip, you must provide voltage level shifting or some other form of buffers. Exposing the pins of ESP8266 to anything larger than 3.6V will damage it.

Connections are as follows:

ESP8266	AVR / SPI	Arduino
GPIO12	MISO	D12
GPIO13	MOSI	D11
GPIO14	SCK	D13
GPIO5	RESET	RST

####Note: -For MISO a voltage divider is required to step down arduino 5v to 3.3v. -MISO,MOSI,SCK connections are unchanable, but RESET (default GIPO5 canbe programatically changed. Use a GPIO other than 0, 2 and 15 (bootselect pins), and apply an external pullup/down so that the target is normally running.

##Wifi config The system will boot with saved previous wifi configuratoions (if any). Confuguration ca be set with web interface.