A prototyping daughterboard to @adamgreen's MiP_ProMini-Pack. This board allows additional sensors and capability to be added to the MiP_ProMiniPack.
This board pulls up JP1 from the MiP_Pro-Mini-Pack in order to keep jumper pins connected to JP1 from getting bent if the MiP falls over backwards. It also enables a switch to be connected elsewhere on the MiP_ProtoPack.
The FTDI connector is not meant to be pulled up by this MiP_ProtoPack. Instead, I recommended right-angle jumper pins be used to connect the FTDI.
Installation is easy! Just solder female pin headers to the ProMini-Pack pin pads and male pin headers to the ProtoPack and connect the two. Soldering pin headers for the 6V, 5V and 3.3V pin pads is optional.
The bare MiP ProtoPack.
The MiP ProtoPack with pin headers installed.
The MiP ProtoPack assembled and installed.
A close-up of the MiP ProtoPack assembled and installed.