Skip to content
Jasper Slits edited this page Nov 15, 2021 · 44 revisions

Welcome to the ithowifi wiki!

To buy visit this page https://www.nrgwatch.nl/ (Dutch) or https://www.tindie.com (English).

This Wiki covers the installation and configuration of the add-on for both the CVE and non-CVE units, integration with home automation software and more.

Note: the add-on hardware and software is the result of reverse engineering and endless hours of testing and debugging. It is not endorsed or supported by Itho Daalderop.

The add-on covers various use-cases so consider these first before obtaining it.

With or without CC1101 module?

When ordering add-on, you need to decide on CC1101 or not. The add-on works fine with add-on but if you want to link existing remotes, you can use the CC1101 transceiver to pair the existing remotes and read its commands and - if applicable - CO2 values.

Supported devices

The following Itho devices are supported or have been tested by the community. Use this table to select the right add-on.

Device Type Add-on Comments
CVE ECO 2 Fan CVE This unit is also sold by the brand 'Heatrae Sadia' in the UK
CVE ECO RFT SE/SP * Fan CVE
CVE-S eco fan RFT Fan CVE
CVE-S S CO2 Fan CVE CO2 sensor not usable with this add-on
HRU 200 ECO Fan CVE Also sold as 'Elektrodesign EHR 140 Akor BP' and 'Heatrae Sadia Advance Plus'
DemandFlow Fan non-CVE
QualityFlow Fan non-CVE
HRU-350 Heat Exchanger non-CVE WTW
HRU ECO Heat Exchanger non-CVE WTW
WPU 5G Heat pump non-CVE Experimental support only

Installation

The add-on hardware and installation steps differs per unit type.

  • Addon for CVE
    This applies to the Itho Daalderop CVE-S and related units.

  • Addon for non-CVE
    This applies to DemandFlow, QualityFlow and HRU-350 and supported WTW units.

  • Addon for WPU Heat Pump
    This uses the non-CVE add-on but applies to Itho Daalderop WPU Heat Pump like 5G. This is today expirimental and is limited to reading status values only.

Remotes and CO2 sensors

Integration

Once the CVE or non-CVE add-on is installed, automation is a logical next step. Use either the Web API or MQTT for the basics.

Guidance for modern home automation systems Home Assistant, Node-RED, HomeBridge and Domoticz is covered here

Issues?

See here how to report issues via GitHub.

On Gathering of Tweakers (Dutch only) forum, there is active thread with users of the add-on. See here: https://gathering.tweakers.net/forum/list_messages/1976492/0

Clone this wiki locally