diff --git a/Marlin/Configuration.h b/Marlin/Configuration.h
index 160ebb0c746e..1592f41a06dc 100644
--- a/Marlin/Configuration.h
+++ b/Marlin/Configuration.h
@@ -633,9 +633,9 @@
 #define USE_XMIN_PLUG
 #define USE_YMIN_PLUG
 #define USE_ZMIN_PLUG
-#define USE_XMAX_PLUG
+//#define USE_XMAX_PLUG
 //#define USE_YMAX_PLUG
-#define USE_ZMAX_PLUG
+//#define USE_ZMAX_PLUG
 
 // Enable pullup for all endstops to prevent a floating state
 #define ENDSTOPPULLUPS
@@ -1046,8 +1046,8 @@
 #define Z_PROBE_LOW_POINT          -5 // Farthest distance below the trigger-point to go before stopping
 
 // For M851 give a range for adjusting the Z probe offset
-#define Z_PROBE_OFFSET_RANGE_MIN -20
-#define Z_PROBE_OFFSET_RANGE_MAX 20
+#define Z_PROBE_OFFSET_RANGE_MIN -10
+#define Z_PROBE_OFFSET_RANGE_MAX 10
 
 // Enable the M48 repeatability test to test probe accuracy
 //#define Z_MIN_PROBE_REPEATABILITY_TEST
@@ -1400,7 +1400,7 @@
 
 #if ENABLED(Z_SAFE_HOMING)
   #define Z_SAFE_HOMING_X_POINT X_CENTER  // X point for Z homing
-  #define Z_SAFE_HOMING_Y_POINT Y_CENTER  // Y point for Z homing
+  #define Z_SAFE_HOMING_Y_POINT Y_CENTER // Y point for Z homing
 #endif
 
 // Homing speeds (mm/min)