Skip to content
Eric Helgeson edited this page Nov 29, 2020 · 34 revisions

Setup Arduino IDE

  1. Install 1Arduino IDEversion1.8.x` - https://www.arduino.cc/en/software
    1. Instructions may require extra steps to allow for serial/usb access depending on your OS. Read all instructions carefully.
  2. Follow these instructions carefully as well - https://github.com/rogerclarkmelbourne/Arduino_STM32/wiki/Installation
    1. Note I used the Arduino SAM Boards (32-bits ARM) Cortext-M3) version 1.6.12
    2. Additional Help https://sites.google.com/site/ericmklaus/projects-1/stm32f103-minimum-system-development-board/arduino-ide-for-stm32103-board
    3. Some additional hints here - https://github.com/ztto/ArdSCSino-stm32/issues/5
  3. Install SdFat - Tools -> Manage Libraries -> SdFat by Bill Greiman version 1.1.4
  4. Make sure the correct board is selected Generic STM32F103C series - Copy the latest .ino file into a sketch and compile.
  5. Flash using your preferred method.

Flashing

Soon.

Making Gerber files

https://support.jlcpcb.com/article/44-how-to-export-kicad-pcb-to-gerber-files