forked from MS3FGX/Bluelog
-
Notifications
You must be signed in to change notification settings - Fork 0
/
bluelog.conf
86 lines (59 loc) · 2.44 KB
/
bluelog.conf
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
# Default Bluelog configuration file
#
# Unless noted otherwise, all values in this file should either be YES or NO.
#
# There are some sanity checks in place, but trying to set unreasonable numbers
# or odd characters for values may cause magic smoke to escape.
# You have been warned.
#--------------------------------Basic Options---------------------------------#
# VERBOSE: Display found devices on the console.
VERBOSE = NO;
# QUIET: Turn off nonessential terminal output.
QUIET = NO;
# DAEMON: Daemonize Bluelog so that it runs in the background.
DAEMON = NO;
# HCIDEVICE: The Bluetooth interface number to use for scanning. The default
# is 0, which corresponds to hci0.
HCIDEVICE = NO;
#-------------------------------Logging Options--------------------------------#
# GETNAME: Perform name inquiry on discovered devices.
GETNAME = NO;
# GETMANUFACTURER: Perform hardware manufacturer lookups on discovered devices.
GETMANUFACTURER = NO;
# SHOWCLASS: Write the raw device class to the log file.
SHOWCLASS = NO;
# FRIENDLYCLASS: Write human readable class info to log file rather than raw.
FRIENDLYCLASS = NO;
# SHOWTIME: Write timestamps to log file.
SHOWTIME = NO;
# OBFUSCATE: Hide the device part of the MAC, leave OUI intact.
OBFUSCATE = NO;
# ENCODE: Perform one-way hash on discovered MAC.
ENCODE = NO;
# AMNESIA: Number of minutes until Bluelog "forgets" a discovered device, and
# logs it again as if it's new. Setting this value to 0 will cause Bluelog
# to continually log the same devices. Set to -1 to disable amnesia mode.
AMNESIA = -1;
#-------------------------------Output Options---------------------------------#
# LIVEMODE: Switch into "Bluelog Live", see README.LIVE for details.
LIVEMODE = NO;
# BLUEPROPRO: Setup log file for .ronin's BPP project.
BLUEPROPRO = NO;
# SYSLOGONLY: Write log entries to syslog. See README.NET
SYSLOGONLY = NO;
# UDPONLY: Write log entries to UDP socket. See README.NET
UDPONLY = NO;
#-------------------------------Network Options--------------------------------#
# NODENAME: Uncomment to manually set node name. Default is system hostname.
#NODENAME = Bluelog Node;
# SERVERIP: The IP Bluelog should send UDP packets to.
SERVERIP = 127.0.0.1;
# SERVERPORT: Listening port on server.
SERVERPORT = 1123;
# PREFIX: Start each UDP message with the node's name.
PREFIX = YES;
# BANNER: Report when first connecting to server.
BANNER = NO;
# HANGUP: Send disconnect message when Bluelog exits
HANGUP = NO;
# EOF