Separate N3 and N9 interfaces do not work if listed separately

[yoursunny]

In my environment, the UPF is expected to use separate network interfaces for N3 and N9 interfaces.
The example UPF config allows two methods to write the configuration:

If there are multiple connection, set addr to 0.0.0.0 or list all the addresses

In the first method, I can write as:

gtpu:
  forwarder: 'gtp5g'
  ifList:
    - addr: '0.0.0.0'
      type: 'N3'

In the second method, I can write as:

gtpu:
  forwarder: 'gtp5g'
  ifList:
    - addr: '172.25.194.6'
      type: 'N3'
    - addr: '172.25.196.6'
      type: 'N9'

As tested, only the first method works.
This is caused by forwarder.NewDriver only listens on the first configured IP address, and ignores other addresses in ifList:

go-upf/internal/forwarder/driver.go

Lines 53 to 58 in efae753

	for _, ifInfo := range cfgGtpu.IfList {
	mtu = ifInfo.MTU
	gtpuAddr = fmt.Sprintf("%s:%d", ifInfo.Addr, factory.UpfGtpDefaultPort)
	logger.MainLog.Infof("GTP Address: %q", gtpuAddr)
	break
	}

Suggested solution is updating the example config, asking user to take the first method only.