The phone application supports Tasker:
This event is triggered each time, a new glucose value is received. The event contains these variables:
| Tasker Variable | glucodata.Minute Variable | Description |
|---|---|---|
| %alarm | Alarm | Alarm value (0: no alarm, 6/14: very high, 2/10: high, 3/11: low, 7/15: very low) |
| %arrow | - | Calculate unicode arrow for the current rate value |
| %delta | - | Delta per minute between the current and the last value (mg/dl or mmol/l) |
| %dexcomlabel | - | Calculated dexcom specific label for the current rate value |
| %glucose | glucose | Glucose value in the unit, defined in Juggluco app (mg/dl or mmol/l) |
| %rate | Rate | Rate of change of the glucose value |
| %ratelabel | - | Calculated label for the current rate value |
| %rawvalue | mgdl | Glucose value in mg/dl |
| %sensorid | SerialNumber | Serial number of the current used sensor |
| %time | Time | Timestamp in ms since 1.1.1970 |
| %timediff | - | Duration in ms between the current and the previous received value |
| %unit | - | Unit of the glucose value, either mg/dl or mmol/l |
This event is triggered after 5 and 10 minutes, if there is no new value received in this time
This event contains all variables from the New glucose value event and addtional:
| Tasker Variable | glucodata.Minute Variable | Description |
|---|---|---|
| %obsolete_time | Time since last value | Time in minutes (5 or 10) since last value was received. |
This event is only triggered, if Juggluco triggers an alarm. This event contains all variables from the New glucose value event.
This state is triggered by wear connection state changes.
This state is triggered by Android Auto connection state changes.
With this action you can change different settings of the phone and wear application.