You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
struct {
unsigned int dc_as_cmd_phase: 1; /*!< D/C line value is encoded into SPI transaction command phase /
unsigned int dc_low_on_data: 1; /!< If this flag is enabled, DC line = 0 means transfer data, DC line = 1 means transfer command; vice versa /
unsigned int octal_mode: 1; /!< transmit with octal mode (8 data lines), this mode is used to simulate Intel 8080 timing /
unsigned int lsb_first: 1; /!< transmit LSB bit first /
} flags; /!< Extra flags to fine-tune the SPI device */
The text was updated successfully, but these errors were encountered:
esp_lcd_panel_io_i80_config_t io_config = {
.cs_gpio_num = EXAMPLE_PIN_NUM_CS,
.pclk_hz = EXAMPLE_LCD_PIXEL_CLOCK_HZ,
.trans_queue_depth = 10,
.dc_levels = {
.dc_idle_level = 0,
.dc_cmd_level = 0,
.dc_dummy_level = 0,
.dc_data_level = 1,
},
.flags = {
.swap_color_bytes = !LV_COLOR_16_SWAP, // Swap can be done in LvGL (default) or DMA
},
struct {
unsigned int dc_as_cmd_phase: 1; /*!< D/C line value is encoded into SPI transaction command phase /
unsigned int dc_low_on_data: 1; /!< If this flag is enabled, DC line = 0 means transfer data, DC line = 1 means transfer command; vice versa /
unsigned int octal_mode: 1; /!< transmit with octal mode (8 data lines), this mode is used to simulate Intel 8080 timing /
unsigned int lsb_first: 1; /!< transmit LSB bit first /
} flags; /!< Extra flags to fine-tune the SPI device */
The text was updated successfully, but these errors were encountered: