Skip to content

Latest commit

 

History

History
56 lines (44 loc) · 2.47 KB

README.md

File metadata and controls

56 lines (44 loc) · 2.47 KB
Raw

ESP32 NTP Nixie Tube Clock Controller

This hardware/software combination implements a Nixie tube digital clock that never needs setting as it gets the current time and date by polling Network Time Protocol (NTP) servers on the Internet. The clock's time is synchronized to NTP time periodically. Use of the TimeZone library means that Daylight Savings Time (DST) is automatically taken into consideration so no time change buttons are necessary. Clock can run in 24 hour or 12 hour mode.

This program uses the WiFiManager library to allow WiFi credentials to be set via a web interface.

Picture

How it works:

When the program is first started it creates a wireless access point called NixieClock that the user needs to connect to and then if the user points his/her browser to 192.168.4.1, a page is presented that allows the credentials for the actual WiFi network to be entered. This only needs to be done once since the credentials will be stored in EEPROM and will be used from that point forward.

Once WiFi connection has been established, it uses NTP to initialize the real-time clock (RTC). If ESP32 cannot connect to the WiFi network using the stored crecentials, it will fall back to the real-time clock (RTC).

Press the mode button to enter WiFi AP configuration mode. Long-press the mode button to reset the ESP32.

The hardware consists of the following parts: ESP32 Nixie Tubes Clock Arduino Shield NCS314 for xUSSR IN-14 Nixie Tubes (https://gra-afch.com)

The connections between the ESP32 board and the Nixie Clock Shield are as follows:

ESP32 Pin Shield Pin Function

GIOP18        SCK        SPI Clock
GIOP23        MOSI       Master Out Slave In (data from ESP32->clock)
SS            LE         Latch Enable
A18           DOT1       Neon dot 1
A18           DOT2       Neon dot 2
A16           PWM1       Green LED drive
A14           PWM2       Red LED drive
A13           PWM3       Blue LED drive
17            SHTDN      High voltage enable
A15           SET        Set (mode) button
16            UP         Up button
A10           DOWN       Down button
A4            BUZZER     Buzzer pin

The ESP32 is powered (via Vin) with 5VDC from a 5 volt regulator driven from the 12 VDC supply. The shield is powered directly from the 12 VDC supply.

Based on ESP8266_NTPNixieClock by Craig A. Lindley and NixeTubesShieldNCS314 by GRA & AFCH.