You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
original sketch looks lo be for an earlier revision of the Nixie NCS314 board. I have the v2.2 which does not use a HV enable or sperate dots control. The pin layout looks to be:
LEDR A14
LEDG A17
LEDB A18
Latch SS
Mode A12
Up A7
Down A10
Buzz A19
The Demos D1 R32 Arduino board would be ideal for this project, but some of the pin assignments are different. Here is the pinout:
The SPI pins are the same, I think. Can you revise the sketch to use the Wemos board pins? Thanks.
The text was updated successfully, but these errors were encountered: