printer-velleman-k8200-2013.cfg

# This file contains common pin mappings for the Velleman K8200 and
# 3Drag 3D printers (circa 2013). To use this config, the firmware
# should be compiled for the AVR atmega2560.

# Based on config from Martin Malmqvist and Per Hjort.

# See the example.cfg file for a description of available parameters.

[stepper_x]
step_pin: ar54
dir_pin: !ar55
enable_pin: !ar38
step_distance: .0125
endstop_pin: ^ar3
position_endstop: 0
position_max: 200
homing_speed: 50

[stepper_y]
step_pin: ar60
dir_pin: !ar61
enable_pin: !ar56
step_distance: .0125
endstop_pin: ^ar14
position_endstop: 0
position_max: 200
homing_speed: 50

[stepper_z]
step_pin: ar46
dir_pin: !ar48
enable_pin: !ar63
step_distance: .0025
endstop_pin: ^ar18
position_endstop: 0.5
# Set position_max to 200 if you have the original Z-axis setup.
position_max: 250

[extruder]
step_pin: ar26
# Remove the "!" from dir_pin if you have an original extruder
dir_pin: !ar28
enable_pin: !ar24
# You will have to calculate your own step_distance.
# This is for the belted extruder https://www.thingiverse.com/thing:339928
step_distance: .001333
nozzle_diameter: 0.400
filament_diameter: 2.85
heater_pin: ar10
sensor_type: ATC Semitec 104GT-2
sensor_pin: analog13
control: pid
pid_Kp: 21.503
pid_Ki: 1.103
pid_Kd: 104.825
min_temp: 0
max_temp: 250

[heater_bed]
heater_pin: ar9
sensor_type: ATC Semitec 104GT-2
sensor_pin: analog14
control: pid
pid_Kp: 75.283
pid_Ki: 0.588
pid_Kd: 2408.103
min_temp: 0
max_temp: 130

[fan]
pin: ar8
kick_start_time: 0.500

[mcu]
serial: /dev/ttyUSB0
pin_map: arduino

[printer]
kinematics: cartesian
max_velocity: 300
max_accel: 1000
max_z_velocity: 10
max_z_accel: 100

# The LCD is untested - "RepRapDiscount 2004 Smart Controller" displays
#[display]
#lcd_type: hd44780
#rs_pin: ar27
#e_pin: ar29
#d4_pin: ar37
#d5_pin: ar35
#d6_pin: ar33
#d7_pin: ar31
#encoder_pins: ^ar16, ^ar17
#click_pin: ^!ar23