This is a simple telegram chat bot to manage our RaspberryPI-based WAN emulator. The bot accepts a few commands described below.
Enumerates all the IP addresses of the device. The IP address of interface eth0 is the uplink IP address, you can use it to ssh into the raspberry in case there is any problem.
Send the command vlan <VLAN_number> to select a particular VLAN. The bot remembers the VLAN you selected, any order you send to the bot after this one will be applied to the selected VLAN.
Send the command up <delay(ms)> <jitter(ms)> <packet loss(%)> <correlation(%)> to apply a particular delay, jitter and packet loss (percentage and correlation) to the vlan selected by the latest vlan command, in the upstream direction (traffic flowing from the VLAN to the uplink).
Only the delay parameter is mandatory. You can type just one, two or three parameters, or all four but set to 0 the things you don't want to use. for instance, if you want to set packet loss with no delay, send:
up 0 0 5 10
You can send up 0 to remove all impairments in the upstream direction.
This is a synonym of the up command. Kept for historical reasons.
Send the message down <delay(ms)> <jitter(ms)> <packet loss(%)> <correlation(%)> to apply a particular delay, jitter and packet loss (percentage and correlation) to the vlan selected by the latest vlan command, in the downstream direction (traffic flowing from the uplink to the VLAN).
Only the delay parameter is mandatory. You can type just one, two or three parameters, or all four but set to 0 the things you don't want to use. for instance, if you want to set packet loss with no delay, send:
down 0 0 5 10
You can send down 0 to remove all impairments in the downstream direction.
This is a synonym of the down command. Kept for historical reasons.
You can chain several commands in the same message, e.g.
- Set 100 ms delay and 10ms jitter upstream in vlan 4094:
vlan 4094 up 100 10 - Set 200 ms delay (100 upstream, 100 downstream) in vlan 4093:
vlan 4093 up 100 down 100 - Clear all impairments in vlan 4094:
vlan 4094 up 0 down 0
To run the bot, you have to provide the telegram API key, either:
- In the command line, with the "-token" parameter.
- In the environment variable IPBOT_API_KEY
If you installed the bot by using the bootstrap script in the piwem project and provided your key during installation, then don't worry. The script created a service to start the application on boot, and saved the API key for you.
If you didn't provide the API key during installation or want to change it afterwards, please check the README at piwem