Configure GeoFences

The Air C2 COP GeoEvent services make use of a number of GeoFences to determine if aircraft are flying in certain areas.

1. Import GeoFences from the AirC2_ACO_Use feature service. Use the following table to configure the GeoFences:

Field	Value
Registered ArcGIS Server	AirC2 AGS Server
Folder	AirC2
Service	AirC2_ACO_Use
Layer	Airspace Control Means - Use
Category Field	AirspaceControlMeasures
Replace All GeoFences in Category	Checked
Name Field	name
Active Field	(Always Active)
WKID	4326
Max Allowable Offset
Time Extent Start
Time Extent End

2. Import GeoFences from the 2DRangeDomes feature service. Use the following table to configure the GeoFences:

Field	Value
Registered ArcGIS Server	AirC2 AGS Server
Folder	AirC2
Service	AirC2_TargetThreatAreas
Layer	Threat Positions Outer
Category Field	RangeDomes
Replace All GeoFences in Category	Checked
Name Field	gtgt_name
Active Field	(Always Active)
WKID	4326
Max Allowable Offset
Time Extent Start
Time Extent End

3. Set up range Dome Synchronization Rules. Use the following table to configure synchronization rules for threat domes.

Field	Value
Name	RangeDomes
Registered ArcGIS Server	AirC2 AGS Server
Folder	AirC2
Service	AirC2_TargetThreatAreas
Layer	Threat Positions Outer
Category Field	RangeDomes
Name Field	gtgt_name
Active Field	(Always Active)
GeoSynch Filter Field
Refresh Interval	1 Minutes
WKID	4326
Max Allowable Offset
Time Extent Start
Time Extent End