Xbox2usbC

An adapter that allows you to plug in USB C wires/devices into the Original Xbox Controller port

Once development is done, this will be available for purchase

Revision One

This is the untested first variant of the Xbox2usbC.

Here is a render:

This is the USB C connector used with this design https://www.digikey.com/en/products/detail/jae-electronics/DX07S024XJ1R1100/5604377?s=N4IgTCBcDaICIA0AMB2AyksAWBApAjAEr75JIgC6AvkA

Revision 1.1

This revision adds two resistors that allow USB C to USB C functionality and it shortens the runs, lessening the use of copper and lowering the cost. I also did away with some vias, cleaning up the board. This revision still uses the same USB C connector as 1.0.

Here are the resistors used: https://www.digikey.com/en/products/detail/stackpole-electronics-inc/RNCF0402DTE102K/3479082 As always, gerber files are in the gerber folder.

Here is a render:

Here is a 3D render of the top and bottom:

Revision 2.0

I finally got the 1.1 PCB and found it barely did not fit in the port. I also made the lower part larger to prevent damage of the controller port on the xbox and the USB C port on the Xbox2usbC.

Here's a render of the top of 2.0:

And here's a render of the bottom:

I've placed an order for this version of the PCB to continue testing. Should be here in a couple weeks.

hield:

This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.