tap-qualtrics

This is a Singer tap that produces JSON-formatted data following the Singer spec.

This tap:

• Pulls raw data from Survey Responses

• Incrementally pulls data based on the input state

---

Quick Start

1. Install

   pip install git+https://github.com/SageData-OOD/tap-qualtrics

2. Create the config file

   Create a JSON file called config.json. Its contents should look like:

    {
        "start_date": "2021-10-28",
        "data_center": "xxxx",
        "client_id": "xxxxxxxxxxx",
        "client_secret": "xxxxxxxxxxxxxxxxxx",
        "refresh_token": "xxxxxxxxxxxxxxxxxxxxxxxxxxxxx"
    }

   • The starts_dte specifies the date at which the tap will begin pulling data.

   • The data_center : Your qualtrics data_center id

     • Where is my data_center?
     • Example - url: https://<yourdatacenterid>.qualtrics.com

   • The refresh_token: The qualtrics OAuth Refresh Token

   • The client_id: The qualtrics OAuth client id

   • The client_secret: The qualtrics OAuth client secret

3. Run the Tap in Discovery Mode

   tap-qualtrics -c config.json -d

   See the Singer docs on discovery mode here.

4. Run the Tap in Sync Mode

   tap-qualtrics -c config.json --catalog catalog-file.json

---

Copyright © 2021 SageData