Fixing Warnings

Warnings appear when there are parts in the assembly that do not fit in any stock.

Some reasons for warnings:

• Your part is too big (either length, width, or thickness) to fit on any of the boards you've defined in the stock tab

  To fix this, either exclude the part from the BOM in onshape if it's not required for the cutlist (like dowels or screws) or add larger stock.

• There is no stock defined for the part's material.

  Either assign a valid material to the part or add the material to the stock tab. If the material is "Unknown", then you haven't specified a material for the part.