CronosMaker not reacting to XLoader

[Glasairman]

I wanted to upgrade an old board to grbl 1.1 but getting no reaction.
My XLoader settings (frontman for avrdude) are ATMega328/COM4/57600 , no reaction so I suspect the Bootloader is defective. I cannot see any USBAsp port anywhere (I have an AVR Programmer)

Any advice?

[lalo-uy]

If you export compiled binary in Arduino IDE , the .bin and .hex, with and without bootloader are left in the script folder. Just use the standar soft you have with that avr programmer. Dont forget to set the fuses. El El sáb, 13 jul. 2024 a la(s) 07:03, Glasairman ***@***.***> escribió:

…

I wanted to upgrade an old board to grbl 1.1 but getting no reaction. My XLoader settings (frontman for avrdude) are ATMega328/COM4/57600 , no reaction so I suspect the Bootloader is defective. I cannot see any USBAsp port anywhere (I have an AVR Programmer) Any advice? — Reply to this email directly, view it on GitHub <#1255>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/ACXBW4JTPKEUVVVJB3O6BB3ZMD3PBAVCNFSM6AAAAABK2EQ5A6VHI2DSMVQWIX3LMV43ASLTON2WKOZSGQYDMOBSHEYTSMA> . You are receiving this because you are subscribed to this thread.Message ID: ***@***.***>