Home

Welcome to the LCD-show wiki! Raspberry Pi LCD Driver installation instruction (online installation) This manual is applicable to all series of Raspberry Pi LCD, Raspberry Pi board should be connected to Internet during the installation.

---

LCD driver for the Raspberry PI Installation

1.)Step1, Install Raspbian official mirror

a)Download Raspbian official mirror:
https://www.raspberrypi.org/downloads/
b)Use“SDFormatter.exe”to Format your TF Card
c)Use“Win32DiskImager.exe” Burning mirror to TF Card

2.) Step2, Clone my repo onto your pi

Use SSH to connect the raspberry pi,
And Ensure that the raspberry pi is connected to the Internet before executing the following commands:

sudo rm -rf LCD-show
git clone https://github.com/goodtft/LCD-show.git
chmod -R 755 LCD-show
cd LCD-show/

3.)Step3, According to your LCD's type, excute:

In case of 2.8" LCD
sudo ./LCD28-show

In case of 3.2" LCD
sudo ./LCD32-show

In case of 3.5" GPIO Display
sudo ./LCD35-show

In case of 3.5" HDMI Display-MPI3508
sudo ./MPI3508_480_320-show
or
sudo ./MPI3508_600_400-show
or
sudo ./MPI3508_720_480-show
or
sudo ./MPI3508_810_540-show
or
sudo ./MPI3508_960_640-show

In case of 3.5" DPI Display-MPI3510
sudo ./MPI3510-show

In case of 3.97" LCD
sudo ./LCD397-show

In case of 4.3" LCD
sudo ./LCD43-show

In case of 5" LCD
sudo ./LCD5-show

In case of 7inch(B)-800X480 RPI LCD
sudo ./LCD7B-show

In case of 7inch(C)-1024X600 RPI LCD
sudo ./LCD7C-show

If you need to switch back to the traditional HDMI display
sudo ./LCD-hdmi

Wait a few minutes,the system will restart automaticall , enjoy with your LCD.