Introduction | Setup | Backup | Restore | Switch firmware | Other options | Screenshots | Build | FAQs | Changelog | Limitation

Features

• Backup partitions
• Restore partitions
• Switch between stock and thingino firmware
• No need to disassemble your camera
• Dry run option debugging
• Initramfs shell for manual debugging if you have serial connection
• Seamlessly boot with wz_mini_hacks on the next boot
• Customize partitions with custom scripts support
• Windows-friendly setup progress

Supported cameras

SoC	Camera model	Support status	Model code
Ingenic T20	Wyze Cam v2	✅ Supported	v2
	Wyze Cam Pan	⚠️ Untested	pan_v1
Ingenic T31	Wyze Cam v3	✅ Supported	v3
	Wyze Cam Floodlight	⚠️ Untested	v3
	Wyze Cam Pan v2	⚠️ Untested	pan_v2
	ATOM Cam 2	⚠️ Untested	v3c

Disclaimer

I am not responsible for bricking someone's cameras.
DO NOT DISCONNECT POWER when the Switch firmware operation is going on, this would brick your camera (unless you know how to recover with Ingenic Cloner or remove the flash chip and use SPI programmer).
It is also possible to brick your camera if you corrupt the U-boot partition with your custom scripts or inject dangerous commands into the configuration files.

Credits

• Gtxaspec with his ideas, tips, hard work on kernel drivers, U-boot, and testing.
• Mnakada with their Docker image to build the SD card kernel from their repo
• OpenIPC project and people with their tools, firmware, and tips.
• thingino project and people with their tools, firmware, and tips.