released version with new partition laylout is 2024.08.18

docs/firmware/howto/upgrade_8mb.md

@@ -1,7 +1,7 @@
-# Upgrade to 2024.08.xx or newer
+# Upgrade to 2024.08.18 or newer
 
 Upgrading from OpenDTU-OnBattery version 2024.06.03 or older to versions
-2024.08.xx or newer requires physical access to the ESP32 board. The new
+2024.08.18 or newer requires physical access to the ESP32 board. The new
 firmware (factory image including new partition layout) must be written to
 flash using the board's USB connection. This is a one-time operation, and newer
 versions can again be upgraded over-the-air (OTA), unless you continue to use
@@ -72,7 +72,7 @@ OTA support. Other variants use the new layout for 8 MB of flash memory.
 ## Background
 
 To accomodate a larger firmware binary, the ESP32 flash memory partition layout
-changed with the release of OpenDTU-OnBattery version 2024.08.xx. All firmware
+changed with the release of OpenDTU-OnBattery version 2024.08.18. All firmware
 released since then uses this new partition layout. Firmware variants `generic`
 and `generic_esp32` are no longer available.
 

docs/firmware/howto/upgrade_upstream.md

@@ -7,8 +7,8 @@ This is particularly true for the settings.
 However, when switching from OpenDTU to OpenDTU-OnBattery, performing an OTA
 update will fail, as the OpenDTU-OnBattery firmware images are too large to fit
 the upstream's partition layout. This project's partition layout for the ESP32
-flash memory is therefore different from the upstream project as of versions
-2024.08.xx. Follow the respective [upgrade guide](upgrade_8mb.md), which is
+flash memory is therefore different from the upstream project as of version
+2024.08.18. Follow the respective [upgrade guide](upgrade_8mb.md), which is
 also applicable when upgrading from OpenDTU to OpenDTU-OnBattery.
 
 In case you want to switch back to OpenDTU (without losing settings), you may