PEW

Cloning repository

git clone --recurse-submodules https://github.com/interfaced/pew.git

Requirments

Broker setup example

1. You have to configure mqtt-broker with support of websockets, for example mosquitto config:

pid_file /var/run/mosquitto/mosquitto.pid

max_connections -1

listener 9001
protocol websockets

listener 1883 0.0.0.0
allow_anonymous true

log_dest stdout

log_type error
log_type warning
log_type notice
log_type information

connection_messages true
log_timestamp true

2. Run mosquitto server

mosquitto -c /etc/mosquitto/mosquitto.conf

Firmware

First make sure that you have the environment installed as described at: https://github.com/esp8266/Arduino

You can change location of esp8266 toolchain via ESP_ROOT in Makefile

ESP_ROOT = $(HOME)/Arduino/hardware/esp8266com/esp8266

Dependencies

Clone dependent libraries into ~/Arduino/libraries folder

• IRremoteESP8266
• ArduinoJson
• ESP_EEPROM
• pubsubclient

Building

make web
make flash_fs
make flash

Configuration

At first boot board will act as AP pew-config-ap and host web-page at 192.168.4.22:1337.

Via configuration stage you can change next options:

• Network SSID - target AP to connect to
• Network password - target AP pass
• Device name - friendly device name which will be used in topic names (example: webos18)
• MQTT broker address
• MQTT broker port