-
Notifications
You must be signed in to change notification settings - Fork 65
Home
This page is meant to document how well WearOS watches function with Juggluco. Everyone can contribute to this wiki. If you have experience with a certain watch, you can add your observations. Please tell with what type of sensor you use the watch (US Libre 2, EU Libre 2 or Libre 3) and how you use the watch. You can describe how it functions with the sensor directly connected with the sensor and when the phone is directly connected with the sensor and the watch receives its data from the phone. Describe the advantages and disadvantages. In general I can see that the watch needs to be from after Android Wear was renamed to WearOS. This means that it runs Android 8 or higher. Juggluco can't use the NFC in the watch and scanning is always done with the phone.
One of the cheapest WearOS watches currently on the market and it is generally functions in agreement with its price. When the phone is connected with the sensor and the watch receives the glucose values from the phone, the watch functions without difficulty; nearly always receiving glucose values when available. Sometimes sync or reinit is needed. How well it functions when directly connected with the sensor, depends on the sensor and on the activity of the user. A fourth of the sensor have connection errors when I make a walk, but only now and then when I stop walking. The previous description applies to EU Libre 2 sensors. My experience with Libre 3 sensors is more positive, but is restricted to only a few sensors; not enough to say that they have less connection errors than Libre 2 sensors. After how long you need to recharge the battery depends on what you do with the watch. Killing and uninstalling other apps helps to extend battery life, see https://xdaforums.com/t/debloat-galaxy-watch-4.4324147. But don’t expect the battery to last more than 24 hour. At the moment it says that 11 h 23 m is left when 53% full. That is 21 h 30 m when 100% full.
A 30 Euro second hands exemplar functions as well as Watch 4 when directly connected with Libre 2 sensors, except when it is moved very little. When moving very little while I am asleep, Bluetooth of the watch is turned off. This means that it will lose contact with both the sensor and the phone. This can be prevented by using the following command from the computer connected to the watch:
adb shell dumpsys deviceidle disable
See:
https://dontkillmyapp.com/general
https://www.juggluco.nl/JugglucoWearOS/install/adb.html
When directly connected with a Libre 3 it only receives every 2 minutes instead of every minute a glucose value from the sensor. That old watch does about as long with a battery as Watch 4.