dmaengine: qcom: Add GPI dma driver

This controller provides DMAengine capabilities for a variety of peripheral
buses such as I2C, UART, and SPI. By using GPI dmaengine driver, bus
drivers can use a standardize interface that is protocol independent to
transfer data between memory and peripheral.

Link: https://lore.kernel.org/r/20201109085450.24843-4-vkoul@kernel.org
Signed-off-by: Vinod Koul <vkoul@kernel.org>

drivers/dma/qcom/Kconfig

@@ -19,6 +19,18 @@ config QCOM_BAM_DMA
 	  Enable support for the QCOM BAM DMA controller.  This controller
 	  provides DMA capabilities for a variety of on-chip devices.
 
+config QCOM_GPI_DMA
+        tristate "Qualcomm Technologies GPI DMA support"
+        depends on ARCH_QCOM
+        select DMA_ENGINE
+        select DMA_VIRTUAL_CHANNELS
+        help
+          Enable support for the QCOM GPI DMA controller. This controller
+          provides DMA capabilities for a variety of peripheral buses such
+          as I2C, UART, and SPI. By using GPI dmaengine driver, bus drivers
+          can use a standardize interface that is protocol independent to
+          transfer data between DDR and peripheral.
+
 config QCOM_HIDMA_MGMT
 	tristate "Qualcomm Technologies HIDMA Management support"
 	select DMA_ENGINE

drivers/dma/qcom/Makefile

@@ -1,6 +1,7 @@
 # SPDX-License-Identifier: GPL-2.0
 obj-$(CONFIG_QCOM_ADM) += qcom_adm.o
 obj-$(CONFIG_QCOM_BAM_DMA) += bam_dma.o
+obj-$(CONFIG_QCOM_GPI_DMA) += gpi.o
 obj-$(CONFIG_QCOM_HIDMA_MGMT) += hdma_mgmt.o
 hdma_mgmt-objs	 := hidma_mgmt.o hidma_mgmt_sys.o
 obj-$(CONFIG_QCOM_HIDMA) +=  hdma.o