Drum-Gloves Project

Poster Click

INTRODUCTION

  Drums’ Glove is designed for the entertainment and practiced the hand muscle sensory isolation as a designed and developed to control the glove and has a series of sounds like a team drum which include snare drum, tenor drum, bass drum, cymbals, hi-hat and kettledrum for the ordinary people who want to play a team drum that save cost and reduce space. Drums’ Glove was made from Arduino Lilypad and knowledge about drum set model. In the glove has a module that sends a signal to Arduino nano and sends analog signal.

ABOUT THIS PROJECT

  This project was created for education. It was caused by me wanting to play the drums and not having enough money to buy drums to play. Therefore was born as a Drum-Gloves Project It was made for those who like to play drums. But don't have money to buy gloves The gloves will consist of

1. Snare drum
2. Tenor drum
3. Bass drum
4. Cymbals
5. Hi-hat
6. Kettledrum

COMPONENTS AND SUPPLIES

• Arduino Nano R3
• Jeck 3.5 cable
• REGULATOR (+5 VOLTS. 1.5 AMP IC)
• Diode 1N4007 (1A 1000V Rectifier)
• 9V Battery Connector
• Micro SD Card Module
• Switch x6
• Jumper wires
• PCB Board
• Glove

SCHEMATICS

CODE

First things first, let's program the Arduino.

• Download and install the Arduino software from http://arduino.cc.

Use the Libraries manager Click to install

#include <SD.h>
#include <TMRpcm.h>
#include <SPI.h>

If you want to see the full version Click

Set pin

int pong = 10;
int nang = 8;
int kang = 7;  //Set finger pin 
int koy = 6;
int chee = 5;
int hand = 3;

pinMode (pong, INPUT_PULLUP);
pinMode (chee, INPUT_PULLUP);
pinMode (kang, INPUT_PULLUP);  //Set pinmode
pinMode (nang, INPUT_PULLUP); 
pinMode (koy, INPUT_PULLUP);
pinMode (hand, INPUT_PULLUP);

Set speaker librarie

TMRpcm tmrpcm; //Call libraries TMRpcm.h
tmrpcm.speakerPin = 9; //5,6,11 or 46 on Mega, 9 on Uno, Nano, etc

Set SD Card

if (!SD.begin(SD_ChipSelectPin)) {  // see if the card is present and can be initialized:
  Serial.println("SD fail");
}

Check values from switch

v_pong = digitalRead(pong);
v_chee = digitalRead(chee);
v_kang = digitalRead(kang); 
v_nang = digitalRead(nang);
v_koy = digitalRead(koy);
v_hand = digitalRead(hand);

Example of code for pressing and playing music

if (v_pong == 0) {
  delay(time_delay); //delay 50ms
  scan_key(); // Check button
  if ((v_pong == 0) & (v_chee == 1) & (v_kang == 1) & (v_nang == 1) & (v_koy == 1) & (v_hand == 1))  {
    tmrpcm.play("1.wav"); //Play drum (1)

If you want to see the full version Click

IMAGES

Pictures and other videos Click

VIDEO

TEAM

University student

62070169	62070190	62070203	62070206
Viphavadee Sathaporn	Sakarn Bantadjun	Sukawit Bualoy	Supanida Ploykam