Case for Maix Dock board with camera, display and a rotary encoder, intended to be used with Krux Signer
Materials for building a Krux
- Printed parts
- Maix Dock with display and camera
- Rotary Encoder Ky-040
- 4 Screws for plastics (~2.5 mm) x 4mm
- 4 M3 nuts
- 4 M3 x 16mm Allen flat screws
- 5 ~8cm thin wires
- 1cm x 1cm x 1mm thieck adesive foam
Instructions
Print the stl files, clean and test fittings.
Solder wires between board and rotary encoder.
Encoder - Maix Dock
GND <-> GND
+ <-> 3V3
SW <-> Pin 9
DT <-> Pin 10
CLK <-> Pin 11
Use the foam as a flexible spacer between camera and board. It will keep the camera slightly pressed against the enclosure. Carefully place the board, with camera on place and use 2 plastic screws in diagonal to fix the board and camera to the back enclosure.
Put wires in place and use the other 2 plastic screws to mount the encoder.
Put the display in place
Put the front enclosure in place and fix it with M3 screws and Nuts
Flash the firmware and enjoy!
