The nRF DTM is a UI-based or Command line based standalone RF test tool designed for ease of controlling RF Test features of the nRF5 series of Nordic Semiconductor.
-
UI based, and separate Command line based tool for Bluetooth RF test
-
Supports most of Bluetooth DTM RF test features (2Mbps/Coded S8/Coded S2/1Mbps/AoA/AoD/Tx power control)
-
Supports listing supported DTM features of the device
-
Supports high, middle, and low 3 different channel sequential test
-
Supports Nordic vendor-specific commands (Tx Power / Constant Carrier )
-
Supports PER measurement with configurable level to verdict pass/fail
-
Listing DTM available serial port(s) and automatic selection for DTM device
-
Average RSSI measurement (Firmware modification required)
-
Configurable log level to check the test sequence and details
-
Supports predefined configurations configurable settings with .ini
-
Integrated test guide
-
Supports selectable channel map in physical-layer and link-layer channels
-
Support multiple OS (macOS/Windows/Ubuntu)
https://github.com/olleheugene/nRF-DTM/wiki/UI-based-test
- Windows 32bit (available in 2.x.x versions only)
- Windows 64bit / ini file (default configuration file)
- Ubuntu / ini file (default configuration file)
- macOS / ini file (default configuration file)
- Windows 64bit / ini file (default configuration file)
- Ubuntu / ini file (default configuration file)
- macOS-Intel core / ini file (default configuration file)
To run the tool on macOS, hold down the "Control" key and click on the nRF_DTM.
To learn more about nRF DTM, please visit wiki page
This is a personal project for convenient use of DTM. Therefore, Nordic Semiconductor will not be provided with official support for this tool.
But all bug reports and feedback are welcome. :)