I 3D printed a case and fit everything inside it. Upon trying to mount it on my Bow, the case shattered. It was my first ever try at creating a schematic and 3D printing it, so that was to be expected. Currently I have no motivation to revisit this project because I have more important things to do and ideas to tend do.
- Arduino Mega, Uno or Nano
- 1x Pushbutton
- 1x 220 Ohm Resistor
- 3x 1k Ohm Resistor
- 1x Tower Pro SG90 Servo
- 1x 9V Battery or similar power source
- 1x Seven-Segment Display with 3 or 4 digits (only 3 will be in use)
- 1x 5mV 650nm Laser Diode
- 1x Laser Rangefinder Module