Skip to content

Polyphonic Digitally Controlled Oscillator (DCO) controlled by Raspberry Pi Pico PIO

Notifications You must be signed in to change notification settings

polykit/pico-dco

Repository files navigation

Raspberry Pi Pico Polyphonic DCO

This repository contains source code, schematics and PCB for a digitally controlled oscillator (DCO) with up to 6 voices which are driven by a Raspberry Pi Pico. It uses PIO to generate a highly accurate frequency which is controlled by USB or serial MIDI. The analog oscillator part is based on the Juno 106 and generates sawtooth and square wave signal with a 10Vpp amplitude. Amplitude compensation is done by a smoothed PWM signal coming from the Pico.

Key features

  • Digitally controlled analog oscillator using a Raspberry Pi Pico
  • Up to six voices
  • Voice stacking
  • Detuning of voices
  • Frequency modulation (FM)
  • Separate gate signal
  • DIN MIDI serial input
  • USB MIDI input
  • MIDI pitch bend
  • Portamento with adjustable speed

This is how it sounds: Ramp sample Pulse sample Polyphonic sample

I use the DCO in my Polykit-6 polyphonic synthesizer, see https://www.youtube.com/watch?v=vj-DSh6yfM0 and https://www.youtube.com/watch?v=go1mErOdtsU

Schematics and PCB

Raspberry Pi Pico DCO Soldered

Raspberry Pi Pico DCO

Raspberry Pi Pico DCO PCB

Gerber files for the PCB can be found here.

Installation (simple)

Press BOOTSEL button on the Pico while powering it with USB. Copy file build/pico-dco.uf2 onto the USB mass storage device.

Usage

After installing the Pico should register as USB MIDI device. Alternatively serial MIDI input is available. The DCO listens to note on/note off messages on MIDI channel 1. Pitch bend is also supported. Portamento can be enabled by MIDI CC message #65, portamento time can be adjusted by CC message #5.

Detuning, stacking and FM

The build-in analog-to-digital converter can be used to modulate these parameters. You can add an external control voltage (0-3.3V) to that input pins. These features can be disabled by commenting (//) the following lines:

#define USE_ADC_STACK_VOICES // gpio 28 (adc 2)
#define USE_ADC_DETUNE       // gpio 27 (adc 1)
#define USE_ADC_FM           // gpio 26 (adc 0)

References

https://blog.thea.codes/the-design-of-the-juno-dco/

https://electricdruid.net/roland-juno-dcos/

https://www.youtube.com/watch?v=yYnQYF_Xa8g

https://github.com/raspberrypi/pico-examples/tree/master/pio/pwm

https://github.com/raspberrypi/pico-examples/tree/master/pio/pio_blink

https://github.com/raspberrypi/pico-examples/tree/master/pwm/hello_pwm

https://qiita.com/jamjam/items/f2fdd5c072ff348fd809

https://github.com/infovore/pico-example-midi

https://learn.sparkfun.com/tutorials/midi-tutorial/all

http://www.music-software-development.com/midi-tutorial.html

http://midi.teragonaudio.com/tech/midispec/run.htm