Merge pull request #4389 from sarusani/mbl_rename_param_whitespace

Cleanup: whitespace in nProbeRetryCount var
prusa3d · Sep 14, 2023 · f193251 · f193251
2 parents 5f60501 + 2863c9b
commit f193251
Showing 1 changed file with 5 additions and 5 deletions.
diff --git a/Firmware/Marlin_main.cpp b/Firmware/Marlin_main.cpp
@@ -2825,9 +2825,9 @@ static void gcode_G80()
         nMeasPoints = 3;
     }
 
-    uint8_t nProbeRetryCount  = code_seen('C') ? code_value_uint8() : eeprom_read_byte((uint8_t*)EEPROM_MBL_PROBE_NR);
-    if (nProbeRetryCount  > 10) {
-        nProbeRetryCount  = 10;
+    uint8_t nProbeRetryCount = code_seen('C') ? code_value_uint8() : eeprom_read_byte((uint8_t*)EEPROM_MBL_PROBE_NR);
+    if (nProbeRetryCount > 10) {
+        nProbeRetryCount = 10;
     }
 
     const float area_min_x = code_seen('X') ? code_value() - x_mesh_density - X_PROBE_OFFSET_FROM_EXTRUDER : -INFINITY;
@@ -2933,7 +2933,7 @@ static void gcode_G80()
         }
 
         // Go down until endstop is hit
-        if (!find_bed_induction_sensor_point_z(has_z ? z0 - Z_CALIBRATION_THRESHOLD : -10.f, nProbeRetryCount )) { //if we have data from z calibration max allowed difference is 1mm for each point, if we dont have data max difference is 10mm from initial point
+        if (!find_bed_induction_sensor_point_z(has_z ? z0 - Z_CALIBRATION_THRESHOLD : -10.f, nProbeRetryCount)) { //if we have data from z calibration max allowed difference is 1mm for each point, if we dont have data max difference is 10mm from initial point
             printf_P(_T(MSG_BED_LEVELING_FAILED_POINT_LOW));
             break;
         }
@@ -2942,7 +2942,7 @@ static void gcode_G80()
             plan_buffer_line_curposXYZE(Z_LIFT_FEEDRATE);
             st_synchronize();
 
-            if (!find_bed_induction_sensor_point_z(has_z ? z0 - Z_CALIBRATION_THRESHOLD : -10.f, nProbeRetryCount )) { //if we have data from z calibration max allowed difference is 1mm for each point, if we dont have data max difference is 10mm from initial point
+            if (!find_bed_induction_sensor_point_z(has_z ? z0 - Z_CALIBRATION_THRESHOLD : -10.f, nProbeRetryCount)) { //if we have data from z calibration max allowed difference is 1mm for each point, if we dont have data max difference is 10mm from initial point
                 printf_P(_T(MSG_BED_LEVELING_FAILED_POINT_LOW));
                 break;
             }