Connect after rotation

[tprohor]

In demo application: after demo1 figure rotation to some angle it is impossible to connect wire to figure

[Tectu]

Hi,

Thanks for reporting this. Could you add a small video / screencap illustrating the issue just to be sure that we're talking the same thing? Something similar to #33.

[tprohor]

QSchematic.Editor.2023-08-10.12-54-29.mp4

[tprohor]

And another problem: demo crash at close event

[Tectu]

The crash on close has been fixed in 2045bf2 - thanks!

Regarding the connection issue: This is a side-effect of the snap-to-grid policy. I think the best course of action is to add a "magnetic" feature: When drawing a wire, getting close to a connector will lead to a successful connection. Currently, wire connection points are restricted to the grid.

[tprohor]

Thank you!