[tunnel_packet_handler] Add a whitespace in the warning syslog message #11232
Add this suggestion to a batch that can be applied as a single commit.
This suggestion is invalid because no changes were made to the code.
Suggestions cannot be applied while the pull request is closed.
Suggestions cannot be applied while viewing a subset of changes.
Only one suggestion per line can be applied in a batch.
Add this suggestion to a batch that can be applied as a single commit.
Applying suggestions on deleted lines is not supported.
You must change the existing code in this line in order to create a valid suggestion.
Outdated suggestions cannot be applied.
This suggestion has been applied or marked resolved.
Suggestions cannot be applied from pending reviews.
Suggestions cannot be applied on multi-line comments.
Suggestions cannot be applied while the pull request is queued to merge.
Suggestion cannot be applied right now. Please check back later.
Signed-off-by: Yong Zhao yozhao@microsoft.com
Why I did it
This PR aims to add a whitespace in the warning syslog message of process
tunnel_packet_handler
.This minor issue was found by an incident ticket.
How I did it
I added a whitespace in the log string.
How to verify it
I tested on a lab device to intentionally raise an expection and check the fomrat of log messages in syslog.
WARNING swss#tunnel_packet_handler.py: PEER_SWITCH or TUNNEL table not found in config DB
Which release branch to backport (provide reason below if selected)
Description for the changelog
Link to config_db schema for YANG module changes
A picture of a cute animal (not mandatory but encouraged)