[QoS] Support dynamic headroom calculation for Barefoot platforms

cfgmgr/Makefile.am

@@ -15,7 +15,10 @@ dist_cfgmgr_DATA = \
 		buffer_pool_mellanox.lua \
 		buffer_check_headroom_vs.lua \
 		buffer_headroom_vs.lua \
-		buffer_pool_vs.lua
+		buffer_pool_vs.lua \
+		buffer_check_headroom_barefoot.lua \
+		buffer_headroom_barefoot.lua \
+		buffer_pool_barefoot.lua
 
 if DEBUG
 DBGFLAGS = -ggdb -DDEBUG

cfgmgr/buffer_check_headroom_barefoot.lua

@@ -0,0 +1,6 @@
+local ret = {}
+
+table.insert(ret, "result:true")
+table.insert(ret, "debug:No need to check port headroom limit as shared headroom pool model is supported.")
+
+return ret

cfgmgr/buffer_headroom_barefoot.lua

@@ -0,0 +1,147 @@
+-- KEYS - profile name
+-- ARGV[1] - port speed
+-- ARGV[2] - cable length
+-- ARGV[3] - port mtu
+-- ARGV[4] - gearbox delay
+
+-- Parameters retried from databases:
+-- From CONFIG_DB.LOSSLESS_TRAFFIC_PATTERN
+--      small packet percentage:    the parameter which is used to control worst case regarding the cell utilization
+--      mtu:                        the mtu of lossless packet
+-- From STATE_DB.ASIC_TABLE:
+--      cell size:                  cell_size of the ASIC
+--      pipeline_latency:           the latency (XON)
+--      mac_phy_delay:              the bytes held in the switch chip's egress pipeline and PHY when XOFF has been generated
+--      peer_response_time:         the bytes that are held in the peer switch's pipeline and will be send out when the XOFF packet is received
+
+local lossless_mtu
+local small_packet_percentage
+local cell_size
+local pipeline_latency
+local mac_phy_delay
+local peer_response_time
+
+local port_speed = tonumber(ARGV[1])
+local cable_length = tonumber(string.sub(ARGV[2], 1, -2))
+local port_mtu = tonumber(ARGV[3])
+local gearbox_delay = tonumber(ARGV[4])
+
+local config_db = "4"
+local state_db = "6"
+
+local ret = {}
+
+-- Pause quanta should be taken for each operating speed is defined in IEEE 802.3 31B.3.7.
+-- The key of table pause_quanta_per_speed is operating speed at Mb/s.
+-- The value of table pause_quanta_per_speed is the number of pause_quanta.
+local pause_quanta_per_speed = {}
+pause_quanta_per_speed[400000] = 905
+pause_quanta_per_speed[200000] = 453
+pause_quanta_per_speed[100000] = 394
+pause_quanta_per_speed[50000] = 147
+pause_quanta_per_speed[40000] = 118
+pause_quanta_per_speed[25000] = 80
+pause_quanta_per_speed[10000] = 67
+pause_quanta_per_speed[1000] = 2
+pause_quanta_per_speed[100] = 1
+
+-- Get pause_quanta from the pause_quanta_per_speed table
+local pause_quanta = pause_quanta_per_speed[port_speed]
+
+if gearbox_delay == nil then
+    gearbox_delay = 0
+end
+
+-- Fetch ASIC info from ASIC table in STATE_DB
+redis.call("SELECT", state_db)
+local asic_keys = redis.call("KEYS", "ASIC_TABLE*")
+
+-- Only one key should exist
+local asic_table_content = redis.call("HGETALL", asic_keys[1])
+
+for i = 1, #asic_table_content, 2 do
+    if asic_table_content[i] == "cell_size" then
+        cell_size = tonumber(asic_table_content[i+1])
+    end
+    if asic_table_content[i] == "pipeline_latency" then
+        pipeline_latency = tonumber(asic_table_content[i+1]) * 1024
+    end
+    if asic_table_content[i] == "mac_phy_delay" then
+        mac_phy_delay = tonumber(asic_table_content[i+1]) * 1024
+    end
+    -- If failed to get pause_quanta from the table, then use the default peer_response_time stored in state_db
+    if asic_table_content[i] == "peer_response_time" and  pause_quanta == nil then
+        peer_response_time = tonumber(asic_table_content[i+1]) * 1024
+    end
+end
+
+-- Fetch lossless traffic info from CONFIG_DB
+redis.call("SELECT", config_db)
+local lossless_traffic_keys = redis.call("KEYS", "LOSSLESS_TRAFFIC_PATTERN*")
+
+-- Only one key should exist
+local lossless_traffic_table_content = redis.call("HGETALL", lossless_traffic_keys[1])
+for i = 1, #lossless_traffic_table_content, 2 do
+    if lossless_traffic_table_content[i] == "mtu" then
+        lossless_mtu = tonumber(lossless_traffic_table_content[i+1])
+    end
+    if lossless_traffic_table_content[i] == "small_packet_percentage" then
+        small_packet_percentage = tonumber(lossless_traffic_table_content[i+1])
+    end
+end
+
+-- Fetch the shared headroom pool size
+local shp_size = tonumber(redis.call("HGET", "BUFFER_POOL|ingress_lossless_pool", "xoff"))
+
+-- Calculate the headroom information
+local speed_of_light = 198000000
+local minimal_packet_size = 64
+local cell_occupancy
+local worst_case_factor
+local propagation_delay
+local bytes_on_cable
+local bytes_on_gearbox
+local xoff_value
+local xon_value
+local headroom_size
+
+if cell_size > 2 * minimal_packet_size then
+    worst_case_factor = cell_size / minimal_packet_size
+else
+    worst_case_factor = (2 * cell_size) / (1 + cell_size)
+end
+
+cell_occupancy = (100 - small_packet_percentage + small_packet_percentage * worst_case_factor) / 100
+
+if (gearbox_delay == 0) then
+    bytes_on_gearbox = 0
+else
+    bytes_on_gearbox = port_speed * gearbox_delay / (8 * 1024)
+end
+
+-- If successfully get pause_quanta from the table, then calculate peer_response_time from it
+if pause_quanta ~= nil then
+    peer_response_time = (pause_quanta) * 512 / 8
+end
+
+if port_speed == 400000 then
+    peer_response_time = 2 * peer_response_time
+end
+
+bytes_on_cable = 2 * cable_length * port_speed * 1000000000 / speed_of_light / (8 * 1024)
+propagation_delay = port_mtu + bytes_on_cable + 2 * bytes_on_gearbox + mac_phy_delay + peer_response_time
+
+-- Calculate the xoff and xon and then round up at 1024 bytes
+xoff_value = lossless_mtu + propagation_delay * cell_occupancy
+xoff_value = math.ceil(xoff_value / 1024) * 1024
+xon_value = pipeline_latency
+xon_value = math.ceil(xon_value / 1024) * 1024
+
+headroom_size = xon_value
+headroom_size = math.ceil(headroom_size / 1024) * 1024
+
+table.insert(ret, "xon" .. ":" .. math.ceil(xon_value))
+table.insert(ret, "xoff" .. ":" .. math.ceil(xoff_value))
+table.insert(ret, "size" .. ":" .. math.ceil(headroom_size))
+
+return ret

cfgmgr/buffer_pool_barefoot.lua

@@ -0,0 +1,30 @@
+-- KEYS - None
+-- ARGV - None
+
+local result = {}
+local config_db = "4"
+local state_db = "6"
+
+redis.call("SELECT", state_db)
+local asic_keys = redis.call("KEYS", "ASIC_TABLE*")
+local cell_size = tonumber(redis.call("HGET", asic_keys[1], "cell_size"))
+
+-- Based on cell_size, calculate singular headroom
+local ppg_headroom = 400 * cell_size
+
+redis.call("SELECT", config_db)
+local ports = redis.call("KEYS", "PORT|*")
+local ports_num = #ports
+
+-- 2 PPGs per port, 70% of possible maximum value.
+local shp_size = math.ceil(ports_num * 2 * ppg_headroom * 0.7)
+
+local ingress_lossless_pool_size_fixed = tonumber(redis.call('HGET', 'BUFFER_POOL|ingress_lossless_pool', 'size'))
+local ingress_lossy_pool_size_fixed = tonumber(redis.call('HGET', 'BUFFER_POOL|ingress_lossy_pool', 'size'))
+local egress_lossy_pool_size_fixed = tonumber(redis.call('HGET', 'BUFFER_POOL|egress_lossy_pool', 'size'))
+
+table.insert(result, "ingress_lossless_pool" .. ":" .. ingress_lossless_pool_size_fixed .. ":" .. shp_size)
+table.insert(result, "ingress_lossy_pool" .. ":" .. ingress_lossy_pool_size_fixed)
+table.insert(result, "egress_lossy_pool" .. ":" .. egress_lossy_pool_size_fixed)
+
+return result

cfgmgr/buffermgr.cpp

@@ -196,7 +196,7 @@ task_process_status BufferMgr::doSpeedUpdateTask(string port)
     // Although we have up to 8 PGs for now, the range to check is expanded to 32 support more PGs
     set<string> lossless_pg_combinations = generateIdListFromMap(lossless_pg_id, sizeof(lossless_pg_id));
 
-    if (m_portStatusLookup[port] == "down" && m_platform == "mellanox")
+    if (m_portStatusLookup[port] == "down" && (m_platform == "mellanox" || m_platform == "barefoot"))
     {
         for (auto lossless_pg : lossless_pg_combinations)
         {