Electronic Modules

A few libs, including a lot of Commodore / CSG parts

This project is about designing a 1.5 bit stage Pipeline ADC & the OpAmp required for its MDAC.

Schematic, Layout Design & Simulation in 180nm Technology

Low cost, low part count CH32V003-based oscilloscope

1/2 channel 4-20 mA to voltage converter boards using LMP8640 current sense monitor.

《电子系统设计-基础和测量系统篇》理论计算用Mathematica代码

A simple yet powerful dummy/electronic load, with minimum component requirements and a lot use cases.

Headphone Amplifier project featuring the NE5532 OP-Amp and a powerful Class AB output stage

Learn to design and build an 4 channel LM35 temperature sensor chip Signal conditioner amplifier circuit based on the popular opamp LM324 using Kicad 6.0.The board can be used to monitor temperature from 4 different sources at the same time and can be used for building your own data acquisition system.

voltage and current regulated power supply

Standalone "interposition-transparent" multichannel DI/splitter/recorder unit

TA Ship work and Various other Projects done using LTSpice for the fulfilment of Analog Electronics Course at BITS Pilani.

Analog Circuit design using ABC algorithm

A folded-cascode OTA with 3.3V power supply and 54.27 dB DC gain with 66.8MHz unity frequency

Accurate and high-current analog function generator

A 2 stage CMOS OTA with Differential amplifier with active load as the first stage followed by Common Source stage using Cadence

This MCC based MPLAB X example shows how to calibrate the gain and offset of the OPAMP when configured as a Programmable Gain Amplifier (PGA). The internal DAC and ADC are used to perform the calibration procedure. No external components are required.

This MCC based MPLAB X IDE example shows how to interface an electret microphone with a microcontroller (MCU) using the Analog Signal Conditioning (OPAMP). In addition to the microphone, only one resistor and one capacitor are required.