Installation Instructions

Behringer X-Touch Mini

The XTM will only work with NK2Tray when it is in MC Mode.

1. Before you plug the cable into the XTM, locate the MC button in the lower left of the panel.
2. Keep that button pressed while you plug in the cable and the XTM turns on. All the buttons will flash twice and you'll know that it's in MC mode from the small light that will appear in the top right of the panel, right above the text, MC MODE.

You can now launch NK2Tray and start using it.

To get the XTM out of MC Mode, you simply unplug the cable and repeat the above steps.

KORG nanoKONTROL2

1. Download and install the drivers from KORG, found at the bottom of the page.
2. If you want the lights to work, you also have to download and install KORG KONTROL Editor, found just above the drivers section, where it says Software.
3. In KORG KONTROL Editor, click Common found right under CONTROL and then under LED Mode set it to External instead of Internal.
4. At the top of the screen, click Communication and then select Write Scene Data.

You can now launch NK2Tray and start using it.