The Janus Controller is a Brushless motor driver with an on-board magnetic encoder, a three-phase MOSFET driver, three MOSFET half-bridges, a temperature sensor and current sensing resistors.

Open source ESC firmware.

FOC_ESC hardware design repository

With SINUSOIDAL BLDC control. Offers much quieter and smoother motor operation.

Sensorless Brushless Motor ESC firmware

Arduino library to control precisely a Brushless Motors without an ESC, same interface as Servo library.

Brushless Gimbal

S06S 250W Torque Simulation Sine Wave Controller

Thrust, voltage, amperage, and RPM sensing designed to replace the internal electronics in the Turnigy Thrust stand or a custom built stand, running on a Tiva C Launchpad with the IO Booster Pack.

Extension for cheap chinese 550W sewing machine motor (brushless servo motor)

STM32 project to send arming sequence and throttle values to REV35 35A 30A BLheli_S 3-6S 4 in 1 Brushless motor controler using timer channels and DMA

Example code for our electronic speed controller (ESC) products!

This is a PCA9685 PWM Module Library for Raspberry pi Using Wiring Pi Library! That can be used for Driving Motors, LEDs, etc.

One RP2040 Pico drives two brushless motors! SimpleFOC + Halls + 2304 drivers + TO-220 mosfets or IGBTs. Plugs directly into 450x automower motors. Trying for low cost + lots of flexibility + solder it at home + repairable. Works as a 3x DC motor controller as well.

Oneshot125 ESC support for esp8266

A curated list of documents, written in Markdown, applicable to the making stuff awesome webpage/fb group, for n*rf blasters

Arduino Uno, IMU-GY85 multirotor based.