Skip to content

WM220 GPS Module board

mefistotelis edited this page Dec 5, 2022 · 5 revisions

Table of Contents

Function
Variants
Parts
Programming
External interfaces
Service interfaces
Board view
Schematics

Function

The GPS module receives messages from GNSS satellites and provides the Flight Controller with current global coordinates.

The GPS Patch Antenna usually has factory cut-ins to improve impedance match. One corner of the antenna is also cut, to widen bandwidth. The antenna is excited through a coaxial line, from other side of the board.

Variants

There are multiple versions of the board:

Marking Overview
P01559.08

Parts

Version P01559.08 components

Marking Amt. Pkg. Function Specification
INPAQ G244 1 Ceramic patch antenna for GNSS band

Programming

The u-blox modules are programmable, but there is no capability of updating GPS firmware via WM220 firmware package.

Chips Firmware Description
todo n/a

External interfaces

Connector on the board is:

Marking Overview
Tied 6 Wires Supplies power and allows I/O with the board

Tied 6 Wires connector

Here is the connector pinout:

Pin Function
1 SCA
2 SCL
3 TX
4 RX
5 GND
6 +5V

Service interfaces

The following service pads exist on this board:

Marking Overview
TODO

Board view

Top of a P01559.08 board, antenna visible:

GPS Module board v8 top

Bottom of the P01559.08 board, SMD components visible:

GPS Module board v8 bottom

Schematics

No schematics available.

Clone this wiki locally